SamriddhiElectronics & Automation
Call the bench +91 98181 82488
WhatsApp
Home / About Us About the company

Built on the bench,
not in a showroom.

Samriddhi Electronics and Automation is an industrial electronics repair workshop based in Mohan Nagar, Ghaziabad — repairing the boards that keep factory floors running.

Senior technician at Samriddhi Electronics and Automation inspecting a control card
Our story

A repair-first approach to industrial automation

Industrial automation equipment fails in patterns — a blown output on a PLC card, a shorted IGBT on a drive, a cracked digitiser on an HMI. Most of the time, the whole unit doesn't need replacing; the fault does. Samriddhi Electronics and Automation was set up around that principle: open the enclosure, find the actual failure, and repair it at the component level.

Working out of Anand Industrial Estate in Mohan Nagar, we serve manufacturing units, panel builders and maintenance teams across Ghaziabad and the wider NCR who need equipment back on the line without the cost and lead time of a brand-new unit.

PLC VFD AC / DC Drives HMI Soft Starters Control Cards
Why teams choose us

What working with us looks like

01

Component-level diagnosis

We trace faults down to the actual component instead of swapping whole assemblies where it isn't needed.

02

Multi-brand expertise

Siemens, Allen Bradley, ABB, Mitsubishi, B&R, Yaskawa, Schneider, Omron, Rockwell, Delta, Emerson and more.

03

Load-tested before dispatch

Every repaired unit is run under test conditions before it's cleared to go back to your panel.

04

Straight answers on cost

You get a diagnosis and a quote before any repair work starts — no surprise charges.

05

Local turnaround

Based in Mohan Nagar, Ghaziabad, with drop-off and pickup for units across the NCR.

06

Warranty on repairs

Every job leaves with a warranty period, so a repeat fault is covered, not billed again.

Close inspection of a circuit board under magnification at the Samriddhi workshop
How we work

Every unit gets the same discipline

Whichever brand or device comes to the bench, the process stays consistent: visual inspection, power-up diagnostics, component-level fault tracing, repair, and full load testing before the unit is packed for return. It's the same discipline whether it's a single HMI panel or a batch of drives from a shutdown.

We also keep a written note with every job — what failed, what we replaced, and what to watch for — so your maintenance log stays accurate.

See Our Repair Process

Bring your faulty automation equipment to a bench that explains the fault.

Message on WhatsApp Contact Us